Bath house water tank steam heater correct installation method

There are many types of steam heaters in the bathhouse, but the basic functions and shapes are similar. They are all submerged steam-water mixing heaters, mainly including: HJ immersion type steam-water mixer, CLP steam-jet heater, HX steam-heating muffler, HJ scroll type. Soda mixer. The steam bath heater of the bathhouse is heated directly by steam and water. It has high thermal efficiency and is easy to install. It is widely appreciated by customers.

The steam bath heater of the bathhouse is a flange interface. The steam pipe is connected to the water tank (pool) and connected by flanges. Proper installation can reduce noise and vibration. The following are some of the ways to properly install the bath heater steam heater:

1. A single submerged steam-water mixer should be installed in the middle of the water tank. When multiple units are used in parallel, they should be evenly arranged;
2. The bottom of the submerged steam-water mixer is about 200mm from the bottom of the water tank, and the water-immersed mixer should be more than 100mm;
3. The steam pipe introduced into the water tank should be fixed and there should be no looseness;
4. Install a check valve on the steam pipe near the water source to prevent water backflow accidents;
5. If there is any impurity in the steam pipe (new pipe, long-term pipe), the filter must be installed.