Today, we will teach you from the inside to the outside and complete the maintenance of the rice transplanter in five steps!

Everyone sees that the first thing that is seen is the appearance, so the first point is the appearance and maintenance inspection.

Check whether the external parts are clean and whether the damaged parts are replaced; whether there is rust or not, and whether the moving parts are rusted.

The second part is the heart of the rice transplanter - the maintenance inspection of the engine.

Check whether the air filter is unobstructed and the sponge is clean; if the gasoline is drained, the oil is turned off; the crankcase gear oil is replaced and the gear oil is clean; slowly pull the recoil starter pull rope for a few times, whether it is rotating normally, No sense of compression.

The third step to do a good job of hydraulic maintenance inspection

Check the degree of wear of the hydraulic belt (primary belt); whether the hydraulic fluid is sufficient. Clean; whether the hydraulic part of the movable parts is flexible, whether the oil injection at the oil; hydraulic copy of the floating board is sensitive.

The fourth step is to do a good part of maintenance inspection

Check whether the planting gear box, planting arm and side chain box are filled with butter and oil; whether the planting arm is working properly; whether the clearance between the picking pinch and the cutting door is correct; whether the seedling volume adjustment in the vertical direction is normal or not; Whether the vertical delivery is normal or not, and whether the star wheel is rotating normally or not.

Finally do a good part of maintenance inspection

Check whether the adjustment of the shift lever is reliable; whether the running wheel runs normally; whether the left and right steering cables are filled with oil.

Do this "five steps", correctly maintain the transplanter, extend the service life of the transplanter, and let it create more value for you!

Poly Aluminium Chloride

Poly aluminium chloride (PAC) is a new type high efficiency inorganic polymer coagulant, adopting advanced manufacturing technique and quality raw material, show the features of low impurity, high molecula weight, and superior coagulating effect.

I. Poly Aluminium Chloride Properties

1. Its dosage lower than aluminum sulfate (based on Al2O3) and water treatment cost is lower than other inorganic flocculants.
2. The product can cause quick formation of flocs, big flocs formation and rapid precipitation. Its treatment capacity is 1.3-3.0 times of other inorganic flocculants.
3. It enjoys wide-range adaptability for different-temperature source water and a good solubility.
4. It is slightly corrosive and easy for operation.
5. The liquid product is suitable for automatic dosing. Furthermore, it will not block pipes over long-time usage.

II. Description

III. Poly Aluminium Chloride Application:

1. Its purifying effect on low-temperature, low-turbidity and heavily organic-polluted raw water is much better than other organic flocculant, furthermore, the treatment cost is lowered by 20%-80%.

2. It can lead to quick formation of flocculant (especially at low temperature) with big size and rapid precipitation service life of cellular filter of sedimentation basin.

3. It can adapt to a wide range of pH value (5−9), and can reduce the pH value and basicity after processing.

4. The dosage is smaller than that of other flocculants. It has wide adaptability to the waters at different temperatures and at different regions.

5. Higher basicity, lower corrosive, easy for operation, and long-term use of non-occlusion.

Poly Aluminium Chloride,PAC 30% Poly Aluminum Chloride,28% Oly Aluminium Chloride,Yellow Poly Aluminium Chloride

Shandong Tiancheng Chemical Co., Ltd. , https://www.tianchengchemical.com