Seven Tips for Maintenance of Agricultural Machinery

The maintenance of agricultural machinery has a significant effect on improving the dynamic and economical efficiency of agricultural machinery. In practice, the use of farm machinery maintenance and maintenance techniques can quickly achieve the goal.

1. Cleverly remove dirt from the fine oil filter. The dirt on the inner wall of the oil filter is difficult to remove. The grease can be applied to the inner wall of the rotor with a layer of paper. The dirt is attached to the paper during the work. When the paper is removed during maintenance, the dirt can be removed.

2. Cleverly remove dirt from the iron filter. The iron filter of the air filter is difficult to clean. The filter element can be immersed in diesel fuel, ignited and burned. After the fire is extinguished, the filter element is tapped with a wooden stick to make the soot fall off and the dirt on the filter element can be removed. .

3. Qiaozhi tire leaks slowly. Take two tablespoons of talcum powder, pull off the valve core, make a funnel with hard paper, insert the valve, talc powder into the inner tube, when the irrigation can not enter, you can remove the funnel, turn the wheel and then irrigation, and then install the valve The core is full of gas.

4. Clever bending tubing. The copper tubing is hard and hard to bend. It is possible to burn red with charcoal and immediately cool it in water to make it soft and pliable.

5. Skillfully repair high pressure tubing heads. The two ends of the high-pressure fuel pipe are connected with the injector and the oil valve, and the sealing accuracy is maintained by the machining accuracy of the contact surface and the fastening force of the pipe nut. Once the contact surface wears and leaks oil, a circle can be cut from the waste cylinder pad. Copper skin, a small hole in the middle, pad between the head and the pit can be.

6. Cleverly remove valve pin clips. When the valve is disassembled, it is not noticed. The valve pin clip easily pops out to lose or hit the face. A suitable sleeve can be used to cover the valve spring seat, and the sleeve can be tapped with a hand hammer, and the valve pin clip can jump into the sleeve without flying out.

7. Coinciding with metal shavings in the guillotine groove. The simple method is to evenly apply a layer of chalk on the surface of the boring knife to easily remove the swarf.

Cilastatin

Cilastatin Acid,Imipenem Cilastatin,Cilastatin Intermediate,Imipenem Cilastatin Cost

Xinxiang Haibin Pharmaceutical Co.,Ltd , https://www.carbapenemspharmacy.com