Precocious and high-yielding tomato
1. Potato juice sprouting. Potato (tuber) tubers are frozen in a freezer freezer for 3 to 5 days. After they are removed, they are allowed to thaw naturally and then juiced. The tomato seeds to be sown are soaked in potato juice for 12 hours. Use a thick, lint-free cloth to cover the potatoes, spread the soaked seeds loosely, keep the seeds out of contact with each other, cover with polyethylene film to prevent drying, but keep them breathable and place them in a warm place. After the seeds germinate, they are inserted into the soil for nursery. According to experiments, germination using the above method can make tomatoes mature 15 to 20 days earlier than conventional methods. 2. Seedlings are planted horizontally. Horizontal planting of tomatoes is generally faster than conventional cultivation. The slow seedling period is shortened by 3 to 5 days, and the survival rate is increased by 15% to 20%. The harvesting period is 7-10 days earlier and the yield is increased by 20% to 30%. The specific approach is: on the basis of fine soil preparation and base fertilizer application, a good north-south direction should be followed, and the width should be covered with a plastic film. Then ditch the ditch by line spacing, about 7 cm deep, then dig holes according to the spacing of the plants, about 5 cm deep. After the hole is made, one-third of the leaves and the buds of the base of the seedling are wiped off. Miaoshungou is put in place. The roots face into the south and the head heads into the ditch toward the north, covering the soil until the blade part is wiped, and the mulch is covered. In the greenhouse cultivation, the lower branches can be cut to promote root growth. To plant tomato horizontally, we must pay attention to the following two points: First, we must plant high and long plants according to the height of the seedlings, and plant the dwarf plants so that they are not mixed together; second, the weight of the selected plants should not be less than 8 g. The height of the aerial part of the seedling plant is about 10 centimeters and it is made obliquely. 3. Spray the cow's urine on the leaf surface. The fresh cow urine is poured into the sprayer, and when the stomata of the tomato leaf are opened at noon, they are evenly sprayed on both sides of the leaf and can be carried out during the whole growth period. Generally can increase production by 18% to 25% or more. However, it should be noted that cow urine collected on the day is sprayed on the same day; during the fruiting period, cow urine should not be sprayed for about 10 days before fruit picking to prevent the fruit surface from being contaminated. 4. Clever spray chicken, rabbit fecal fluid. In tomato fruit period, about 6% of the concentration of chicken, rabbit manure soak the filtrate directly on the positive and negative sides of the leaf, tomato fruit can be fast, mature, good quality, high yield. The preparation method of the manure solution is: Take 3 kg of dried chicken manure or dried rabbit manure, add 50 kg of clear water, and put it together in a wooden barrel or large tile jar and seal and soak it for 6 to 7 days. After fully fermenting, stir and filter evenly. Slag can be used. 5. Press side to go to the main stem. According to the rooting characteristics of the tomato stem, after the fruiting period of the tomato is over, 2 to 3 lateral branches are spawned from the bottom of the main stem to make it bent to the ground and pressed and fixed with the loam, with only 2 or 3 pieces exposed at the top. Leaves, until all the side branches are fixed and poured once. After the lamination, the greenhouse cultivation temperature is controlled at 20-25°C during the day and 10-15°C at night. The soil moisture is maintained at 60%-70% and the air humidity is 45%-55%. After the decline of the main tomato fruit stem, immediately cut the main stem from the pressure of the lateral branch, and strengthen the management of fertilizer and water, usually 115 to 20 days or so lateral branches can be flowering results. 6. In addition to the old branches, leave the main stem. After selecting good breeds, cultivating strong seedlings, reasonable close planting, and finely pourable tubes, leave the main stem after the results and cut off the old ones. Article 2 The main stem can sprout again. The more knotted the fruit is, the more productive and high-life the tomato tree is. This method not only saves the seeds, but also increases the yield by about 2 times. The result is 15 to 20 days in advance. Tomatoes cultivated in open field, pay attention to insulation and dryness, while earthworms are used to facilitate the safe wintering of the plants.
Sunson Denim Finishing Enzyme is designed for denim finishing processing. Cellulase is regarded as a "biological pumice", which makes the indigo dye separated from denim on the washing process, and a few doses of enzyme can replace several kilograms of pumice. The less use of pumice, the smaller damage to the clothing and the smaller loss of the machine and the less sand dust in the washing environment. "Biological pumice" provides a possibility for increasing the effect of the finishing process. For example, it is possible to decolorization jeans without damaging the fabric. And the washing machine can contain less pumice and more clothing, and can also improve the production efficiency greatly.
Coenzyme N-3000 is high concentrated and neutral cellulase preparation, which is designed specially for denim abrasion process. It is only recommended for formulations that are used in bio-washing of denim garments and acts on denim garments to impart high abrasion and fading effect, which can also be used for the processing of the cotton, hemp, viscose, yarn and Lyocell.
Coenzyme NL Ultra is high concentrated and liquid neutral cellulase preparation. It is specially developed for fabric and garment biopolishing under neutral condition; it can combine with hydrogen peroxide removal in the same dye bath, and is exclusively designed for formulator.
Coenzyme NL Ultra II is new developed and high concentrated neutral cellulase preparation. It is designed for fabric and garment biopolishing under neutral condition, and specially developed for denim abrasion with high contrast and low back staining; it can combine with hydrogen peroxide removal in the same dye bath, and is exclusively designed for formulator.
Benefits:
Excellent bio-polishing effect
Clean and even fabric surface
This product should be stored in a cool and dry place in sealed container, avoiding insolation, high temperature and damp. The product has been formulated for optimal stability. Extended storage or adverse conditions such as higher temperature or higher humidity may lead to a higher dosage requirement.
Enzyme preparations belong to protein, which may induce sensitization and cause anaphylaxis in sensitized individuals. Long-term exposure may cause minor irritation for skin, eyes or nasal mucosa, so any direct contiguity with human body should be avoided. If irritation or allergic response for skin or eyes develops, consult a doctor.
Denim Finishing Enzymes,Denim Finishing Enzymes For Woven,Liquid Acid Cellulase Enzyme,Denim Finishing Enzymes Powder Sunson Industry Group Co., Ltd , https://www.sunsonchinaenzymes.com
Softer handfeel
Brighter colors
Environmental-friendly & bio-degradation